Great tips or with lon you wish I knew sooner

1. Wi-Fi Waves twice as powerful

At least anyone think shell cans of beer, cans of soft drinks again are useful for one of the modern technological inventions of the 20th century. Layers of aluminium foil used for gas water can improve the speed of Wi-Fi from two up to four outline.

The steps taken:

Gather the materials and tools needed: cans of beer/soft sheath, knife, scissors.

Drink water in and then clean hygiene from the inside out.

Removed khoen lid cans.

Cut off the bottom part of the casing the entire cans.

Sharp knife for cutting 3/4 way round lid cans a about 2 cm.

On the opposite side the part has not been slit, cut a vertical line from the bottom up to the road has just cut near the lid cans.

Users manual carefully open the two sheets of aluminum foil to the two sides.

The cans have nested on the antenna on the Wi-Fi player through the lid cans. Direction open cans on the shell you use the lapton, or any location would need to catch a wave.

2. Do the Lantern

Material:

With a few simple steps were there right from the shell Lantern lovely beer cans.

To make the Lantern middle incoGreat tips or with lon you wish I knew sooner from beer crust, you need to prepare:

-Types of cans Shell (Shell Shell fresh water cans, beer cans cocacola, fanta ...)

-Knife carved, size

-Drag

How to do:

First you prepare crust of cans of beer. When do Chinese lanterns from the shell type, the cans do not need sharpening to removed lid part where, you just washed, Peel plateau to cans. Note use the shell type cans of beer, soft shelled fresh water, not too hard!

Use the Great tips or with lon you wish I knew soonerasure and the streak nearly the length of the shell. You use the tip to create killer knife strokes. Draw the striped lines are together for the remainder of the shell width of cans!

Then the vertical paper knife carved straight guys just follow the lines evenly. If no knife, scissors can be used to cut, but how to cut 2 cans a shell to the head lanterns are sturdy.

Lightly press the top casing cans down to the cutting line swells, forming the curve of the Lantern. Coated with paint or color for the cans to shell the Mid-Autumn Lantern DIY is more beautiful.