How to keep flowers fresh longer in the gladiolus days Tet

1. Before plugging the States must contact the average wash clean with SOAP and then sundried, as the vase was old and often plugged the flower branch software easy to rot as water lilies, for which additional pharmacy, ... After each water change should also contact the average wash clean.

2. If cut slanted cuts to enhance surface-water for flower spike, and when plugged in the face without being cut across the bottom of the vase, flower spike-the water easier.

Don't get water in the jar too much, just enough to plug flooded the wing root about 3-5 cm.

3. If cut flowers from the tree, should cut a little spike stalks to long before plug in the average you can cut off the base of the flower scene for about 3-5 cm (where the column of air in the vessels, obstructing the absorbent of flower spike). When removal of the original paragraph flower spike to embed both into water shoots or root-root branches inserted into tap water is under fire to cut, then plug into spike fast. To do so the water in the jar will be directly exposed to the water column in the vessels of the United States shoots, forming a continuous water column moved to the parts of the hoam shoots keep fresh flowers longer.

4. After leaving the mother plant, the first requirement of the flower spike is water, so after the cut to plug right into the Spike as soon as possible, to flower spike always in water account status, if not prone to spike wilt as they continue to escape steam but no added water. If the prolonged water shortage, flower spike will not likely to back a fresh, or if there is fresh back then was also weak, quickly.

5. Must use clean water to flower (can use warm water approximately 38-400 c, because warm water transported to the flower spike more quickly), do not use the water contains more Calcium, Magnesium. Fluorine water can ruin leaves, flowers, tissue, if water supplies containing Fluorine are contained into the buckets, pots of reserve to wait a few days for this chemical to fly off to invite user to plug in the United States. To change the water daily, when the vase water change to flower stalk, cleaned the plug part is submerged. If the House had available air tub Ozone gas to wash the vegetables, then it is best to use water has neutral gaseous ozone (Ozone gas promotion after the water has been sterilized, very clean) to flower, fresh flowers will last longer)

6. Before plug the cutting is below, not to the leaves in the water causing rot makes water infections, bacteria hang around the stems root cause root rot twig, make the infested water that still makes the water flow in the blocked spike again.

8. Whenever the water change the rot wedge at the base of the stem. Don't get water in the jar too much, just enough to plug flooded the wing root about 3-5 cm because the absorbent was mainly done in cuts. If the original depth plug spike susceptible to bacteria that cause rot. Can use several types of chemicals such as copper Sulfate, Javel water, smoking, ... (concentration 0.05 grams/liter) to inhibit taste rot organisms, fresh flowers will last longer

9. Do not place vases in having direct sunlight shining on (such as the edges of the window), under corrugated heat, often in draughty, under the ceiling or on the television, the radio, because the heat will reduce the lifespan of flowers. The hot air, the wind makes water spike fast, while they are not up to the United States will suffer additional wilt, fast. In the evening before going to sleep, so put the vase on the cold room, cool spot or outside to them "inspired Frost".=