Using this type of high-speed kettle both burns electric money and is life-threatening for the whole family

Cook water constantly

Many people make the mistake of thinking that continuous cooking will save fuel when the kettle is hot. Continuous boiling water causes the thermostat of the super-speed kettle to overheat, resulting in rapid fire. Ideally, let warm to have a break between the heat to cool the tray below to cool down.

In many cases, when the water is heated for a long time, the thermal relay will automatically disconnect the circuit, causing the kettle to stop working, even if the power plug is plugged in, but the light is not on. You need to wait a while to warm down before using it again.

Boil water that is not up to the manufacturer's level

If you boil too much water, it will boil water out of the wall, running down to the hot plate causing electric shock. If the amount of water is too low, boiling water will easily run out and deposit on the bottom of the jar even if there is a danger of fire and electric shock.

Any super speed kettle has the highest and lowest amount of water needed to boil. The symbol is dashed and divided in ml. Next to the highest and lowest bars, there are "Max" and "Min" (the largest and the smallest). You can easily observe the line mark on the body of the jar to adjust the amount of water accordingly.

Do not cover or cover tightly when boiling water

This misconduct both wastes electricity and takes longer to boil water. The electric kettle is designed to have an automatic relay that will disconnect the power when the lid is closed. Therefore, if boiling water is not disconnected, it will cause a risk of fire and explosion.

Use a super speed kettle to cook food

The electric kettle is created to boil water, but it does not have a cooking effect, such as boiled eggs, cook soup or milk, etc. will not be fully cooked.

Use a scaled kettle

When the kettle is scaled, it will reduce the ability to receive heat from the heater, making the water boil longer. In addition, excessive deposits can cause the thermistor relay to fail, causing the kettle to disconnect itself even before the water has been boiled.

Therefore, after 1 period of use, you need to clean the inside of the bottle, remove the deposits for safe use and increase the durability of the bottle.

Fill the kettle with water after boiling

After boiling water, we have a habit of pouring out the warm water. This should be removed immediately because the kettle warms, the heater continues to generate heat even when the power switch is off. If you do not leave the amount of water in the kettle, the thermostat very quickly breaks down. Therefore, it is advisable to leave about 20 ml of water in the kettle, wait until it has cooled down before emptying.

Empty the water immediately after boiling

Hot water - pouring water out of a kettle into a water jug ​​- This is the habit of many people. In fact, this is a mistake that needs to be fixed immediately if you want your kettle to be durable over time.

When the water reaches 100 degrees Celsius, the super speed kettle will disconnect itself, but the inside of the thermostat is still hot. If immediately pouring out the water in the jar will cause the thermostat to change temperature suddenly, leading to a shorter life span.