Young mother 'nice treatment' mold marks on the mat, everyone admires admiringly: But never thought about it

Use salt water and lime powder

With the projectors you take away for a long time without looking at it, there will definitely be a huge mold. They are not only on the projection surface but also deep inside the mat, if only lemon or ordinary water is difficult to clean.

Therefore, it is best to bring the mat soaked in dilute salt water for about 20 minutes. Salt has a very good antibacterial effect, they will clean from deep inside the mold to prevent the return of mold. It's like killing to their feet.

When you bring the mat, you spread a thin layer of lime powder on it. This will help the water on the mat to be sucked away, quickly drying out. At the same time, the stains on the mats were quickly eliminated. The final step is to rinse with clean water and dry in the sun.

Bring sun exposure

With mats only showing mold marks, the quickest way is to bring them to the sun. Because if you wash very easily, it will cause a quick failure. Instead you simply need to carry them in the sun so that the temperature from the sun directly destroys mold is fine.

If it is not sunny, then you can treat it by using medical alcohol or white wine. Alcohol will sterilize without fear of being wet like water so you don't need to worry about getting wet again. Moreover, using alcohol and alcohol also makes the projector retain the oil layer above, helping to shine the ball like new.

Use lemon

In lemon, the acid content is quite high, they are especially effective at removing mold spots. So, you just need to use a piece of lemon to rub the entire face, the mold marks will fade and fade away. After that, you use a wet towel to wipe it once more.

If it is not sunny, you can use a drying dryer. So don't worry about not taking off the root and mold will come back again. Moreover, lemons will also help the mat which has an unpleasant smell because of the long-time moisture becomes fragrant.

Use soap

When the mats are moldy, you want to ensure that it does not get mold again, it is best to eradicate each of them. If so, you need to have acid or detergent solution. Soap is not a bad suggestion.

But you should remember that mats are not like clothes, they are made from bamboo, from sedge, so if you use soap with a high concentration of PH, it will make the projector fast to be broken, broken wire, broken projector. So you should choose soap with moderate pH.

Next, wipe with a dry towel and use laundry soap. Remember to use a scrubbing brush carefully every time to make it completely clean. Finally, you use clean water to wash it again and then bring it to your clothes. If the sun is weak, use a towel to wipe both sides of the mat to remove the water, then bring it to the sun. So, it will not worry about moisture and dryness.