Tip Use the refrigerator to prolong and save energy

The fridge needs to put into place a cool, ventilated

According to the refrigeration specialist, should put the refrigerator in place, limiting the latest on the cramped corner of the House, the back and the two side walls of the fridge are the way the wall is at least 10 cm to ensure the escape of heat. Want air circulation around the refrigerator and to moisture resistant, you can ground than the way cabinet 5 cm. By surrounding temperature in the refrigerator will influence the ability of electric radiator, wear and many more.

Reasonable temperature adjustment

When the cold storage food in cabinets, not many, so adjust the cooling level to medium or lower will save more power. The consumer should use a thermometer to check the temperature with the temperature, cold Chamber at levels 7-8 º C is reached, no need to adjust the maximum level of conditioning. With the frozen pane, adjust the temperature at-18° C instead of 22 º is just enough.

Store food properly to save electricity

To save your refrigerator, you should not be too full of quality food in cabinets, between the food need to snap out of a gap to cold air can for save, power loss will drop; hot food (such as rice, hot water heater, hot food) is to cool the new must give in the refrigerator if not they will do in the cabinet temperature rises too fast do waste more electricity; In particular, you should use food packaging made of metal instead of plastic due to the cold lead to better features, so the time for cooling will be shorten, your are saving more.

Besides, you should note that, in the case of food needed to keep only a small area, cold Chamber to save electricity, you should use the plastic foam filled to keep the cold Chamber in order to narrow the space for cooling of the fridge, help less power consumption while the foam plastic pieces are almost non-conditioning.

To cool the refrigerator compartment on a little ice, frozen food you are about to use to contribute to keep the cold in this pane, limit the operation of cold processing parts due to temperature are, from that save electricity better.

Sanitary refrigerator regularly to save electricity

Need regular hygienic protection b. refrigerator about 1-2 months/times to bacteria, mold has no conditions arise.

Need regular hygienic protection b. refrigerator about 1-2 months/times to bacteria, mold has no conditions arise. Proceed to clean the rubber edge of the section in the door of the refrigerator carefully will help keep the rubber part durability, close snugly, not the steam conditioning many losses to refrigerator operation, better power-saving.

Regularly cleaning the dirt, clinging and accumulates on the surface of hot-staging, cooler, filter, pour off the water cavity due to cooling process created ... to heat exchanges, air conditioning make better faster and consume less power. However when conducting sanitary refrigerator, you need to make sure the source is cut completely to safety.

At the same time, next to memberships sanitary refrigerator periodically, every year once you should check the amount of cooling air and gas if gas shortages are timely additions, if not the main cause of electric power consuming and faked, the longevity of the fridge.

Limit on/off, open the refrigerator to save electricity

In the process of using the fridge, to save on electricity, you should limit disconnect the fridge away from the power source and turn on/off the refrigerator frequently because each launch will spend a large amount of power. In the case of long days without resorting to the fridge, then disconnect the power source but the need to clean up, food in cabinets, closets and cabinets to dry sanitation then closed, using material covered with dust cover above.

At the same time, you need to restrict opening the refrigerator and freezer doors open for too long because when opening the air conditioning inside the cabinets will very quickly with convection hot air outside the Cabinet, making the temperature in the Cabinet. Meanwhile, cooling parts to increase the time, performance caused more power consumption, long the longer lifetime of fridge.

Limit switch off/switch on the fridge

In the process of using the fridge, to save on electricity, you should limit disconnect the fridge away from the power source and turn on/off the refrigerator frequently because each launch will spend a large amount of power. In the case of long days without resorting to the fridge, then disconnect the power source but the need to clean up, food in cabinets, closets and cabinets to dry sanitation then closed, using material covered with dust cover above.

Limit opening the fridge

You need to restrict opening the refrigerator and freezer doors open for too long because when opening the air conditioning inside the cabinets will very quickly with convection hot air outside the Cabinet, making the temperature in the Cabinet. Meanwhile, cooling parts to increase the time, performance caused more power consumption, long the longer lifetime of fridge.

Use glass or porcelain dishes

Glass and ceramic helps balance the temperature in the refrigerator is better than the plastic food containers. Remember the cover to prevent condensation of water.

Not to eat based on the police in the Cabinet of

Pay attention to the food the way some with the in of the refrigerator.

Often to food in contact with the inside of the fridge will do vegetables easily damaged, not to mention cause cooling cabinets work poorly, leading to more power consuming. Pay attention to the food the way some with the in of the refrigerator.

Sweeping behind cabinets

The chilling behind the refrigerator should be sweeping, vacuuming regularly to avoid dust and dirt clog the system. If you have pets, then the toilet as possible are more frequently because it is the ideal place for the furry animal "reside".

Defrost in the refrigerator

Rather defrost in the microwave, make natural defrost by giving food to cool the refrigerator compartment before a night. Defrost food from from delicious than usually, but also significant savings in power consumption.

Clean food before giving in to the fridge

Should clean the food drink before giving in to wardrobes.

Avoid the situation to stagnate water in the bottom cabinets

When scouring avoid status to standing water in the bottom of the Cabinet, the door of the refrigerator, the shell buffers use the clean towel soaked in warm water, then wipe dry (do not use appropriate base or any other substance ... to scrub). Wipe clean dust cloth, soft gust hot rig does not wipe the cloth too moist ... do the water flows into the box in the gust caused a short circuit. Clean the floors, footprint (make sure to dry open against rusty and mouse). After the wipe the inside and outside of the refrigerator is dry in the slot and opening of the Cabinet from 30-40 minutes for ventilation

The handling of common failure in the fridge:

-We often encounter cases of corruption in the refrigerator. You can fix small breakdowns, no need to carry out the repair shop or thanks to Hunter.

-Cabinets, not conditioning: this phenomenon is due to our food too much, the knob position switches-le is not appropriate. You can adjust the amount of food again, to switch the knob to the higher level of conditioning.

-A fan of the cabinets made by indirect methods don't dial is: can we check that the propeller had been stuck not, wire the fan motor bench has not broken and check the fan switch.

-Gear system of the timer broken snow discharge, exposure is not good: we check, if not, you should dial the new changes.

Earthing of the trailers-snow discharge fitting well or not the le not accurate: we check back, right to the face of aluminum hit into the cooler.

-When starting or off the Cabinet heard cries: this phenomenon is due to the 4 screw compressors were fluid starts out. You can do four lined with high-su, cut the power source, remove the screws out and then high-su pieces on cushions, drawing back.=

  • 6582 Views
Loading...