There is no need to call a mechanic, the summer to keep the air conditioner in this way ensures RUNNING THE RU without wasting electricity.

How to clean the air conditioner

Step 1: Switch off the air conditioner. Hang a bag with a mouth wide enough to catch dust and water running down during the air conditioning process.

Step 2: Use 2 hands to raise the air conditioner lid. Gently remove the air filter that is clogging the dust.

Step 3: Use strong water hose to wash the filter net. Then use a mild detergent such as shampoo or shower gel to brush the toothbrush and then scrub the filter net thoroughly.

Step 4: Place the filter net in a shady place without sunshine to filter the net naturally.

Step 5: Mix water and 1 teaspoon of mild detergent (shampoo or shower gel) and put in a spray bottle and spray gently into the slots between the metal leaves, avoid letting water shoot into the circuit board of the air conditioner and then use Toothbrush scrub along the crevices to clean the dust. Note, spray a little downward so that the detergent can creep into each metal leaf or blade.

Step 6: Spray again with clean water and wipe with a dry cloth.

Step 7: Once the sieve is dry, assemble the filter net into the air conditioner and cover it.

Step 8: Open wind mode for about 30 minutes for the machine to be completely dry and clean. Remove the garbage bag. Your air conditioning hours are clean.

Signs that air conditioning needs maintenance

- Poor cooling machine: When the air conditioner shows signs of cold or not cold (turn on for 30 minutes), it is recommended to turn off the circuit breaker and call the repairman to consider. The main reason for this phenomenon is due to broken gas or hot tail fan resulting in cold air conditioning.

- Air conditioner quickly: 2-piece machine belongs to the type of valve, so it cannot be absolutely sealed, allowing the leak at the limit. Normally, the machine is good for about 6 months gas pump / time or 1 year / time. As for new machines that use 1-2 months and have to pump gas, they should review the pipes or valves that leak.

- Air conditioner is flickering: Due to high ampere loading capacity, it is required to have good contact point, not loose. To be sure, you should use a separate CB circuit breaker for air conditioning or a plug but it is a big one. The lowest Ampe load level of air conditioner is always at 4 amps, the Start ability when the machine runs will be at the lowest of 20A for 3-10s.

This is an initial condition that many consumers do not pay attention to and also causes the most vulnerable machine due to flickering voltage while the machine is operating.